Publications

A technical–economic assessment was carried out in this study to determine the possibilities for wind and solar power generation in Afghanistan’s Helmand province. The results showed that most of the province has a solar irradiance of over 400 W/m2 and also showed that wind and solar power generated in the province can be up to twice as cheap as the official price of renewable power in Afghanistan. The most suitable site for solar and hydrogen production was found to be Laškar Gah where solar and hydrogen can be produced at a cost of 0.066 $/kWh and 2.1496 $/kg-H ¯ 2 respectively. In terms of wind power production and hydrogen production from wind the most suitable site was Sang¯ın where wind power and hydrogen could be produced at costs of 0.057 $/kWh and 1.4527 $/kg-H2 respectively. Despite the high potential of wind and solar energy in the Helmand province the most suitable place in this region to produce hydrogen from wind/solar energy was evaluated from technical economic and environmental perspectives with the Multi-Criteria DecisionMaking (MCDM) method. The Stepwise Weight Assessment Ratio Analysis (SWARA) method was used for weighting criteria and the Weighted Aggregated Sum Product Assessment (WASPAS) method was used to prioritize locations. The results show that Sang¯ın is the most suitable place for the construction of a wind hydrogen power plant and Laškar Gah is the most suitable place for the ¯ construction of a solar hydrogen power plant.

Atomic hydrogen produced by corrosion of a low-carbon steel in NaCl – Water solution may markedly affect its certain tensile mechanical and magnetic properties in a complex and peculiar manner. This influence was investigated by employing the intrinsic micromagnetic emission (ME)-response as well as tensile mechanical response of this ferromagnetic material and also by introduction a relevant measurement parameter of specific micromagnetic emission response. In this fashion it was shown that an increase in the hydrogen accumulation with corrosion time leads to an associated increase in the pervasive and embrittling influence expressed by a marked loss in ductility of the material. It was also shown that the competitive interplay of cumulative hydrogen applied stress and plastic strain-induced microstructural damage was related to a specific ME-response parameter by which an increased magnetic hardening tendency of material with corrosion time was established. In general embrittlement and magnetic hardening are parallel products of stress- assisted hydrogen accumulation where magnetic hardening process seems to be in a time processing advance of embrittlement one. The above findings allow to estimate that the magnetic properties are more susceptible to hydrogen effects than the mechanical ones.

The Energy Innovation Needs Assessment (EINA) aims to identify the key innovation needs across the UK’s energy system to inform the prioritisation of public sector investment in low-carbon innovation. Using an analytical methodology developed by the Department for Business Energy & Industrial Strategy (BEIS) the EINA takes a systemlevel approach and values innovations in a technology in terms of the system-level benefits a technology innovation provides.1. This whole system modelling in line with BEIS’s EINA methodology was delivered by the Energy Systems Catapult (ESC) using the Energy System Modelling Environment (ESMETM) as the primary modelling tool.



To support the overall prioritisation of innovation activity the EINA process analyses key technologies in more detail. These technologies are grouped together into sub-themes according to the primary role they fulfil in the energy system. For key technologies within a sub-theme innovations and business opportunities are identified. The main findings at the technology level are summarised in sub-theme reports. An overview report will combine the findings from each sub-theme to provide a broad system-level perspective and prioritisation.



This EINA analysis is based on a combination of desk research by a consortium of economic and engineering consultants and stakeholder engagement. The prioritisation of innovation and business opportunities presented is informed by a workshop organised for each sub-theme assembling key stakeholders from the academic community industry and government.



This report was commissioned prior to advice being received from the CCC on meeting a net zero target and reflects priorities to meet the previous 80% target in 2050. The newly legislated net zero target is not expected to change the set of innovation priorities rather it will make them all more valuable overall. Further work is required to assess detailed implications.

The approach developed aims to identify the methodology that will be used to deliver the minimum cost for hydrogen infrastructure deployment using a mono-objective linear optimisation. It focuses on minimizing both capital and operation costs of the hydrogen transportation based on transportation via truck which represents the main focus of this paper and a cost-minimal pipeline system in the case of France and Germany. The paper explains the mathematical model describing the link between the hydrogen production via electrolysers and the distribution for mobility needs. The main parameters and the assumed scenario framework are explained. Subsequently the transportation of hydrogen via truck using different states of aggregation is analysed as well as the transformation and storage of hydrogen. This is used finally to build a linear programming aiming to minimize the sum of costs of hydrogen transportation between the different nodes and transformation/storage within the nodes.

Considering a simple regenerative Brayton cycle the impact of using different fuel blends containing a variable volumetric percentage of hydrogen in methane was analysed. Due to the potential of hydrogen combustion in gas turbines to reduce the overall CO2 emissions and the dependency on natural gas further research is needed to understand the impact on the overall thermodynamic cycle. For that purpose a qualitative thermodynamic analysis was carried out to assess the exergetic and energetic efficiencies of the cycle as well as the irreversibilities associated to a subsystem. A single step reaction was considered in the hypothesis of complete combustion of a generic H2/CH4 mixture where the volumetric H2 percentage was represented by fH2 which was varied from 0 to 1 defining the amount of hydrogen in the fuel mixture. Energy and entropy balances were solved through the Engineering Equation Solver (EES) code. Results showed that global exergetic and energetic efficiencies increased by 5% and 2% respectively varying fH2 from 0 to 1. Higher hydrogen percentages resulted in lower exergy destruction in the chamber despite the higher air-excess levels. It was also observed that higher values of fH2 led to lower fuel mass flow rates in the chamber showing that hydrogen can still be competitive even though its cost per unit mass is twice that of natural gas.

This paper presents techno-economic modelling results of a nationwide hydrogen fuel supply chain (HFSC) that includes renewable hydrogen production transportation and dispensing systems for fuel cell electric buses (FCEBs) in Ireland. Hydrogen is generated by electrolysers located at each existing Irish wind farm using curtailed or available wind electricity. Additional electricity is supplied by on-site photovoltaic (PV) arrays and stored using lithium-ion batteries. At each wind farm sizing of the electrolyser PV array and battery is optimised system design to obtain the minimum levelised cost of hydrogen (LCOH). Results show the average electrolyser capacity factor is 64% after the integration of wind farm-based electrolysers with PV arrays and batteries. A location-allocation algorithm in a geographic information system (GIS) environment optimises the distributed hydrogen supply chain from each wind farm to a hypothetical hydrogen refuelling station in the nearest city. Results show that hydrogen produced transported and dispensed using this system can meet the entire current bus fuel demand for all the studied cities at a potential LCOH of 5–10 €/kg by using available wind electricity. At this LCOH the future operational cost of FCEBs in Belfast Cork and Dublin can be competitive with public buses fuelled by diesel especially under carbon taxes more reflective of the environmental impact of fossil fuels.

Minerals are essential components in many of today’s rapidly growing clean energy technologies – from wind turbines and electricity networks to electric vehicles. Demand for these minerals will grow quickly as clean energy transitions gather pace. This new World Energy Outlook Special Report provides the most comprehensive analysis to date of the complex links between these minerals and the prospects for a secure rapid transformation of the energy sector.



Alongside a wealth of detail on mineral demand prospects under different technology and policy assumptions it examines whether today’s mineral investments can meet the needs of a swiftly changing energy sector. It considers the task ahead to promote responsible and sustainable development of mineral resources and offers vital insights for policy makers including six key IEA recommendations for a new comprehensive approach to mineral security."





Link to International Energy Agency website

Following up on our report Uncomfortable Home Truths: why Britain urgently needs a low carbon heat strategy Pipeline to 2050 sets out recommendations for BEIS’ forthcoming Heat and Buildings Strategy. Based on the findings of five roundtables held between January and July 2020 with cross-party parliamentarians policy-makers and experts from industry academia and non-governmental organisations the publication calls for a joined-up approach that simultaneously addresses all aspects of heat decarbonisation.<br/>The report highlights that today there is a patchwork of heat policy initiatives. Although they might incentivise positive development in themselves are nevertheless too dispersed and not enough to drive the level of coordinated action that is needed given the complexity of heat decarbonisation. Setting out propositions to tackle challenges associated with the transition to low carbon heat in the areas of governance funding innovation and public engagement; the publication calls for a Heat and Buildings Strategy that shows a step change in terms of ambition for heat decarbonisation.<br/>The report recommends that the Heat and Buildings Strategy needs to put forward a systematic approach that joins up all policy aspects and principles needed for the transition to low carbon heat. Moreover given the cross-sectoral engagement needed between consumers industry research and various levels of the government it argues that the Strategy has to be constructed in a way that simultaneously catalyses action from all stakeholders that are needed to take part in the process for effective heat decarbonisation.

Formation of metal hydrides is a serious complication that occur when hydride forming metals such as zirconium niobium vanadium and magnesium are exposed to long term hydrogen environment. The main concern is that the hydride as being a brittle material has very poor fracture mechanical properties. Formation of hydride is associated with transportation of hydrogen along the gradients of increasing hydrostatic stress which leads to crack tips and other stress concentrators where it forms the hydride. In the present study the thermodynamics of the evolving hydrides is studied. The process is driven by the release of free strain chemical and gradient energies. A phase field model is used to capture the driving forces that the release of the free energy causes. The study gives the conditions that lead to hydride advancement versus retreat and under which conditions the metal-hydride interface becomes unstable and develops a waviness. The spatial frequency spectrum leading to instability is found to depend on the ratio of the elastic strain energy density and parameters related to the interface energy.

The high environmental impacts of transport mean that there is an increasing interest in utilising low-carbon alternative energy carriers and powertrains within the sector. While electricity has been mooted as the energy carrier of choice for passenger vehicles as the mass and range of the vehicle increases electrification becomes more difficult. This paper reviews the shipping aviation and haulage sectors and a range of low-carbon energy carriers (electricity biofuels hydrogen and electro fuels) that can be used to decarbonise them. Energy carriers were assessed based on their energy density specific energy cost lifecycle greenhouse gas emissions and land-use. In terms of haulage current battery electric vehicles may be technically feasible however the specific energy of current battery technology reduces the payload capacity and range when compared to diesel. To alleviate these issues biomethane represents a mature technology with potential co-benefits while hydrogen is close to competitiveness but requires significant infrastructure. Energy density issues preclude the use of batteries in shipping which requires energy dense liquids or compressed gaseous fuels that allow for retrofits/current hull designs with methanol being particularly appropriate here. Future shipping may be achieved with ammonia or hydrogen but hull design will need to be changed significantly. Regulations and aircraft design mean that commercial aviation is dependant on drop-in jet fuels for the foreseeable future with power-to-liquid fuels being deemed the most suitable option due to the scales required. Fuel costs and a lack of refuelling infrastructure were identified as key barriers facing the uptake of alternatives with policy and financial incentives required to encourage the uptake of low-carbon fuels.