Poland

This article presents the results of a comparative scenario analysis of the “green hydrogen” development pathways in Poland and the EU in the 2050 perspective. We prepared the scenarios by linking three models: two sectoral models for the power and transport sectors and a Computable General Equilibrium model (d-Place). The basic precondition for the large-scale use of hydrogen in both Poland and in European Union countries is the pursuit of ambitious greenhouse gas reduction targets. The EU plans indicate that the main source of hydrogen will be renewable energy (RES). “Green hydrogen” is seen as one of the main methods with which to balance energy supply from intermittent RES such as solar and wind. The questions that arise concern the amount of hydrogen required to meet the energy needs in Poland and Europe in decarbonized sectors of the economy and to what extent can demand be covered by internal production. In the article we estimated the potential of the production of “green hydrogen” derived from electrolysis for different scenarios of the development of the electricity sector in Poland and the EU. For 2050 it ranges from 76 to 206 PJ/y (Poland) and from 4449 to 5985 PJ/y (EU+). The role of hydrogen as an energy storage was also emphasized highlighting its use in the process of stabilizing the electric power system. Hydrogen usage in the energy sector is projected to range from 67 to 76 PJ/y for Poland and from 1066 to 1601 PJ/y for EU+ by 2050. Depending on the scenario this implies that between 25% and 35% of green hydrogen will be used in the power sector as a long-term energy storage.

Poland    The present paper is aimed at determining the less investigated effects of hydrogen uptake on the microstructure and the mechanical behavior of the oxidized Zircaloy-2 alloy. The specimens were oxidized and charged with hydrogen. The different oxidation temperatures and cathodic current densities were applied. The scanning electron microscopy X-ray electron diffraction spectroscopy hydrogen absorption assessment tensile and nanoindentation tests were performed. At low oxidation temperatures an appearance of numerous hydrides and cracks and a slight change of mechanical properties were noticed. At high-temperature oxidation the oxide layer prevented the hydrogen deterioration of the alloy. For nonoxidized samples charged at different current density nanoindentation tests showed that both hardness and Young’s modulus revealed the minims at specific current value and the stepwise decrease in hardness during hydrogen desorption. The obtained results are explained by the barrier effect of the oxide layer against hydrogen uptake softening due to the interaction of hydrogen and dislocations nucleated by indentation test and hardening caused by the decomposition of hydrides. The last phenomena may appear together and result in hydrogen embrittlement in forms of simultaneous hydrogen-enhanced localized plasticity and delayed hydride cracking.

The aim of this study was to evaluate the motorization market of electric vehicles powered by hydrogen cells in Poland. European conditions of such technology were indicated as well as original proposals on amendments to the law to increase the development pace of electromobility based on hydrogen cells. There were also presented economic aspects of this economic phenomenon. Moreover survey research was conducted to examine the preferences of hydrogen and electric vehicle users in 5 primary Polish cities. In this way the level of social acceptance for the technological revolution based on hydrogen cells and taking place in the motorization sector was determined.

Fluctuations in renewable energy production especially from solar and wind plants can be solved by large‐scale energy storage. One of the possibilities is storing energy in the form of hydrogen or methane–hydrogen blends. A viable alternative for storing hydrogen in salt caverns is Lined Rock Cavern (LRC) underground energy storage. One of the most significant challenges in LRC for hydrogen storage is sealing liners which need to have satisfactory sealing and mechanical properties. An experimental study of hydrogen permeability of different kinds of polymers was conducted followed by modeling of hydrogen permeability of these materials with different additives (graphite halloysite and fly ash). Fillers in polymers can have an impact on the hydrogen permeability ratio and reduce the amount of polymer required to make a sealing liner in the reservoir. Results of this study show that hydrogen permeability coefficients of polymers and estimated hydrogen leakage through these materials are similar to the results of salt rock after the salt creep process. During 60 days of hydrogen storage in a tank of 1000 m2 inner surface 1 cm thick sealing liner and gas pressure of 1.0 MPa only approx. 1 m3STP of hydrogen will diffuse from the reservoir. The study also carries out the modeling of the hydrogen permeability of materials using the Max‐ well model. The difference between experimental and model results is up to 17% compared to the differences exceeding 30% in some other studies.

This study documents the results of economic assessment concerning four variants of coal gasification to hydrogen in a shell reactor. That assessment has been made using discounting methods (NPV: net present value IRR: internal rate of return) as well as indicators based on a free cash flow to firm (FCFF) approach. Additionally sensitivity analysis has been carried out along with scenario analysis in current market conditions concerning prices of hard coal lignite hydrogen and CO2 allowances as well as capital expenditures and costs related to carbon capture and storage (CCS) systems. Based on NPV results a negative economic assessment has been obtained for all the analyzed variants varying within the range of EUR −903 to −142 million although the variants based on hard coal achieved a positive IRR (5.1–5.7%) but lower than the assumed discount rates. In Polish conditions the gasification of lignite seems to be unprofitable in the assumed scale of total investment outlays and the current price of coal feedstock. The sensitivity analyses indicate that at least a 20% increase of hydrogen price would be required or a similar reduction of capital expenditures (CAPEX) and costs of operation for the best variant to make NPV positive. Analyses have also indicated that on the economic basis only the prices of CO2 allowances exceeding EUR 40/Mg (EUR 52/Mg for lignite) would generate savings due to the availability of CCS systems.

In this work a metal cobalt catalyst was synthesized and its activity in the hydrogen production process was tested. The substrates were water and ethanol. Activity tests were conducted at a temperature range of 350–600 °C water to ethanol molar ratio of 3 to 5 and a feed flow of 0.4 to 1.2 mol/h. The catalyst had a specific surface area of 1.75 m2/g. The catalyst was most active at temperatures in the range of 500–600 °C. Under the most favorable conditions the ethanol conversion was 97% the hydrogen production efficiency was 4.9 mol (H2)/mol(ethanol) and coke production was very low (16 mg/h). Apart from hydrogen and coke CO2 CH4 CO and traces of C2H2 and C2H4 were formed.

The search for fossil fuels substitutes forces the use of new propulsion technologies applied to means of transportation. Already widespread hybrid vehicles are beginning to share the market with hydrogen-powered propulsion systems. These systems are fuel cells or internal combustion engines powered by hydrogen fuel. In this context road tests of a hydrogen fuel cell drive were conducted under typical traffic conditions according to the requirements of the RDE test. As a result of the carried-out work energy flow conditions were presented for three driving phases (urban rural and motorway). The different contributions to the vehicle propulsion of the hydrogen system and the electric system in each phase of the driving route are indicated. The characteristic interaction of power train components during varying driving conditions was presented. A wide variation in the contribution of the fuel cell and the battery to the vehicle’s propulsion was identified. In urban conditions the share of the fuel cell in the vehicle’s propulsion is more than three times that contributed by the battery suburban—7 times highway—28 times. In the entire test the ratio of FC/BATT use was more than seven while the energy consumption was more than 22 kWh/100 km. The amounts of battery energy used and recovered were found to be very close to each other under RDE test conditions.

In December 2019 the European Commission unveiled an ambitious project the European Green Deal which aims to lead the European Union to climate neutrality by 2050. This is a significant challenge for all EU countries and especially for Poland. The role of hydrogen in the processes of decarbonization of the economy and transport is being discussed in many countries around the world to find rational solutions to this difficult and complex problem. There is an ongoing discussion about the hydrogen economy which covers the production of hydrogen its storage transport and conversion to the desired forms of energy primarily electricity mechanical energy and new fuels. The development of the hydrogen economy can significantly support the achievement of climate neutrality. The belief that hydrogen plays an important role in the transformation of the energy sector is widespread. There are many technical and economic challenges as well as legal and logistical barriers to deal with in the transition process. The development of hydrogen technologies and a global sustainable energy system that uses hydrogen offers a real opportunity to solve the challenges facing the global energy industry: meeting the need for clean fuels increasing the efficiency of fuel and energy production and significantly reducing greenhouse gas emissions. The paper provides an in-depth analysis of the Polish Hydrogen Strategy a document that sets out the directions for the development of hydrogen use (competences and technologies) in the energy transport and industrial sectors. This analysis is presented against the background of the European Commission’s document ‘A Hydrogen Strategy for a Climate-Neutral Europe’. The draft project presented is a good basis for further discussion on the directions of development of the Polish economy. The Polish Hydrogen Strategy although it was created later than the EU document does not fully follow its guidelines. The directions for further work on the hydrogen strategy are indicated so that its final version can become a driving force for the development of the country’s economy.

The production storage and use of hydrogen for energy purposes will become increasingly important during the energy transition. One way to use hydrogen is to apply it to power vehicles. This green technological solution affects low-emissions transport which is beneficial and important especially in cities. The authors of this article analyzed the use of hydrogen production infrastructure for bus propulsion in the city of Katowice (Poland). The methods used in the study included a greedy algorithm and cost methods which were applied for the selection of vehicles and identification of the infrastructure for the production storage and refueling of hydrogen as well as to conduct the economic analysis during this term. The article presented the complexity of the techno-economic analysis of the infrastructure and its installation. The key element was the selection of the number of vehicles to the hydrogen production possibilities of an electrolyser and capabilities of the storage and charging infrastructure.

The use of hydrogen as a non-emission energy carrier is important for the innovative development of the power-generation industry. Transmission pipelines are the most efficient and economic method of transporting large quantities of hydrogen in a number of variants. A comprehensive hydraulic analysis of hydrogen transmission at a mass flow rate of 0.3 to 3.0 kg/s (volume flow rates from 12000 Nm3/h to 120000 Nm3/h) was performed. The methodology was based on flow simulation in a pipeline for assumed boundary conditions as well as modeling of fluid thermodynamic parameters for pure hydrogen and its mixtures with methane. The assumed outlet pressure was 24 bar (g). The pipeline diameter and required inlet pressure were calculated for these parameters. The change in temperature was analyzed as a function of the pipeline length for a given real heat transfer model; the assumed temperatures were 5 and 25 ◦C. The impact of hydrogen on natural gas transmission is another important issue. The performed analysis revealed that the maximum participation of hydrogen in natural gas should not exceed 15%–20% or it has a negative impact on natural gas quality. In the case of a mixture of 85% methane and 15% hydrogen the required outlet pressure is 10% lower than for pure methane. The obtained results present various possibilities of pipeline transmission of hydrogen at large distances. Moreover the changes in basic thermodynamic parameters have been presented as a function of pipeline length for the adopted assumptions.